Install Intake Cam On Cam Shaft; Install Crank Gear; Hooking Acr Spring Onto Exhaust Cam Gear - Kohler Courage SV470 Service Manual

Figure 10-28. Spring Installed on ACR Weight.
Figure 10-29. Hooking ACR Spring onto Exhaust
Cam Gear.
on the cam gear is in the 8 o'clock position. Install
Figure 10-30. Installing Exhaust Cam Gear.

Install Intake Cam on Cam Shaft

Thrust Washer
(Intake Side)
Used on
Early Models
Only
Figure 10-31. Installing Intake Cam Gear and
Thrust Washer.

Install Crank Gear

EX timing mark
Figure 10-32. Installing Crank Gear.
slot with the upper drive pin. Rotate the gear and
IN timing mark on the cam gear is in
the 4 o'clock position. Early Models Only: Install
either two or four rivets. The four
12 o'clock position. Hold the crank gear with
the timing marks visible and slide it onto the
crank gear align with the timing marks on the
Section 10
Reassembly
10
10.9