Figure 10-55. Tightening Clip around Sheathing.
Install New Spark Plug
2. Set the gap to 0.76 mm (0.030 in.).
3. Install the spark plug and torque it to 24-30 N·m
Figure 10-56. Installing Spark Plug.
and Air Cleaner Base
1. If the carburetor mounting stud was removed,
reinstall it in the outer cylinder location (closest
®
®
socket or two hex
Stud
Insert
(Some Models)
Figure 10-57. Mounting Stud and Installing Insert
(Some Models).
2. Make sure all the gasket surfaces are clean and
free of any nicks or damage.
3. Install a new intake gasket onto the carburetor
section should be down, toward the engine. If the
it should be towards the back inserted into the
intake port. Be sure the protruding point goes
through the large hole in the gasket, to keep it
Figure 10-58. Installing Intake Gasket and Heat
Section 10
Reassembly
10
10.17