Choke Control Installation; Starting An Engine Equipped With Separate Control Cables - Kohler Courage SV470 Service Manual

Alignment Hole
Figure 5-20. Alignment Hole in Speed Control
Bracket and Throttle Lever. (Early Models)
Later Models:
instead of one. Based upon the intended high
must be made matching the hole in the control
lever with the appropriate alignment hole. Use
lever with the appropriate hole in the control
clamp securely.
Alignment Hole
for 3000 RPM
and Higher
Figure 5-21. Alignment Holes in Speed Control
Bracket and Throttle Lever. (Later Models)

Choke Control Installation

Starting an Engine Equipped with Separate
Control Cables
Alignment Hole
for Less Than
3000 RPM
Fuel System and Governor
control to ensure it stops against the stop screw,
which means it is properly set.
assembly.
stops. Do not force. Then tighten the cable clamp
screw.
slow and fast
into the on position.
2. Start the engine.
and warms up.
The engine/equipment may be operated during
the warm up period, but it may be necessary
warms up.
as soon as engine starts.
Section 5
position
5
on
5.13