Kohler Courage SV470 Service Manual page 99

Section 10
Reassembly
Figure 10-18. Installed Guide Shoe
(Above Serial No. 3618005223).
3. Make sure pivot pin on boss in lower section
of crankcase is clean and free of any nicks, or
surface irregularities. Apply a small amount of
grease to O.D.
4. Apply a small amount of grease to O.D. of guide
pin on PTO side of counterweight and install
the PTO seal. Slightly rotate the counterweight
assembly and guide the outer end of link over
the stationary guide pin in crankcase. Seat link
Control
Link
Figure 10-19. Installing Crankshaft Assembly with
Control Link (Above Serial No. 3618005223).
10.6
Figure 10-20. Installed Control Link on Crankcase
Guide Pin (Above Serial No. 3618005223).
Install Piston Rings
NOTE: For detailed piston inspection procedures
Install Piston to Connecting Rod
1. Assemble the piston, connecting rod, piston pin,
do not force
Figure 10-21. Assembled Piston and Connecting
Rod.
Control
Link
Guide
Pin
and piston ring installation refer to Section 9
Inspection and Reconditioning.