Pto Seal Depth Details; Install Governor Cross Shaft; Install Oil Pump Assembly And Intake Cam Shaft; Installing Oil Pump And Lower Drive Pin On Intake Cam Shaft - Kohler Courage SV470-600 Service Manual

Section 10
Reassembly
Figure 10-2. PTO Seal Depth Details.

Install Governor Cross Shaft

1. Place the thin thrust washer onto the governor
cross shaft as far as it will go.
2. Lightly lubricate the shaft with oil, and install it
from inside the crankcase. See Figure 10-3.
Thin Washer
Governor
Shaft
Figure 10-3. Installing Governor Cross Shaft.
3. Slide the thick thrust washer onto the shaft from
the outside as far as it will go. Secure by inserting
the hitch pin in the machined groove. See Figure
10-4.
10.2
www.SmallEngineDiscount.com
Oil Seal
Figure 10-4. Securing Governor Shaft.
Seal Depth
Install Oil Pump Assembly and Intake Cam
5.5 mm (0.216 in.)
Shaft
1. If the oil pump assembly was removed from the
Figure 10-5. Installing Oil Pump and Lower Drive
Pin on Intake Cam Shaft.
Not For Resale
Hitch Pin
Thick Washer
intake cam shaft, reassemble it onto the shaft.
The drive pin holes are machined to be a
clearance (slip) fit on one side and a press fit on
the other. Support the cam shaft with the
clearance holes up and install the shorter, 2.5 mm
(0.098 in.) diameter pin in the outer hole, closest
to the bottom end. See Figure 10-5 and 10-6.
Center the pin in the shaft.
Oil Pump
Pin In
Outermost
Hole
Intake
Cam
Shaft