Install Fuel Pump; Install Rectifier-Regulator; Install Blower Housing And Flywheel Screen - Kohler Courage SV470 Service Manual

Install Fuel Pump (If Equipped)
speed control bracket with the two M5 screws.
Torque the screws to 6.5 N·m (55 in. lb.) into new
4.0 N·m (35 in. lb.) into used
Figure 10-72. Fuel Pump Mounting Bracket.
Secure with the two M6 screws. Torque the
screws to 9.5 N·m (84 in. lb.)
holes or 5.9 N·m (52 in. lb.) into used holes. Do
not over tighten.
Figure 10-73. Installed Fuel Pump.
regulator onto the crankcase bosses, with the
screws to 6.0 N·m (55 in. lb.)
holes, or 4.0 N·m (35 in. lb.) into used holes.
terminals.
Install Blower Housing and Flywheel
Screen
1. Position the blower housing on the engine and
route the spark plug lead through the underside
Figure 10-75. Installing Blower Housing.
of the blower housing. Align the mounting
locations, then install the four M6 shouldered
the head on one screw, install the screw in the
screws to 11.6 N·m (99 in. lb.)
holes, or 7.7 N·m (68 in. lb.), into used holes. See
Section 10
Reassembly
10
10.21