HIKVISION DS-2CE12DF0T-FS User Manual page 14

4. (Optional) Drill the cable hole, when the cables are
routed through the ceiling.
5. Secure the junction box body on the ceiling with three
PA4 × 25 screws that come with the junction box.
Figure 2-17 Secure the Junction Box Body
6. Route the cables through the bottom cable hole or
the side cable hole of the junction box.
7. Combine the junction box cover with its body and
secure it with screws.
Figure 2-18 Combine the Junction Box Cover and Body
8. Fix the gang box onto the junction box cover with PA4
× 10 screws that come with the junction box.
9. Connect the power cord and video cable and put the
cables back into the junction box.
10. Press the camera base to the gang box. Turn the
camera clockwise until it snaps into the gang box.
11. Refer to step 6 of 2.4.1 Ceiling Mounting Without
Junction Box to adjust the angle and finish the
installation.
2.3.3 Wall Mounting
Before you start:
You need to purchase a wall mount in advance.
Steps:
1. Drill Φ 10 mm screw holes in the wall where you want
to install the wall mount.
2. Use M6 × 75 metal expansion bolts to fix the wall
mount onto the wall.
3. Use PM4 × 10 screws to fix the gang box onto the wall
mount.
Figure 2-19 Finish the Installation
Figure 2-20 Fix the Wall Mount