Table of Contents
Advertisement
Figure 2-9 Secure the Camera to the Ceiling
5. Connect the power cord and video cable.
6. Power on the camera to check whether the image on
the monitor is gotten from the optimum angle. If not,
adjust the camera according to the figure below.
Rotation Position
[0° to 360°]
1). Loosen the trim ring to adjust the pan position [0°
to 360°].
2). Loosen the thumbscrew to adjust the tilt position
[0° to 180°].
3). Loosen the screw to adjust the rotation position
[0° to 360°].
7. Tighten the trim ring and screws to finish the
installation.
2.3
Installation of Type III Camera
2.3.1 Ceiling Mounting Without Junction Box
Steps:
1. Paste the drill template (supplied) to the place where
you want to install the camera.
2. (Optional) For cement ceiling, drill the screw holes
with a 5.5 mm drill and insert the supplied wall plugs.
3. Attach the gang box to the ceiling and secure it with
three PA4 × 25 screws (supplied).
Figure 2-12 Attach the Gang Box to the Ceiling
4. Fit the camera onto the gang box.
Figure 2-10 3-Axis Adjustment
Figure 2-11 Drill Template
Pan Position
[0° to 360°]
Trim Ring
Tilt Position
[0° to 180°]
Thumbscrew
Screw
Advertisement
Table of Contents
