HIKVISION DS-2CE12DF0T-FS User Manual page 11

Figure 2-6 Secure the Junction Box on the Wall
7. Route the cables through the bottom cable hole or
side cable hole of the junction box and connect the
cables.
8. Fix the junction box cover on its body with three PM3
× 16 L6 screws that come with the junction box.
Figure 2-7 Fix the Junction Box Cover on Its
9. Repeat steps 6 to 7 of 2.1.1 Ceiling/Wall Mounting
Without Junction Box to finish the installation.
2.2
Installation of Type II Camera
2.2.1 Ceiling/Wall Mounting Without Junction Box
Before you start:
Ceiling mounting and wall mounting are similar. Following
steps take ceiling mounting as an example.
Note:
For installation with junction box, refers to 2.1.2
Ceiling/Wall Mounting with Junction Box.
Steps:
1. Paste the drill template (supplied) to the place where
you want to install the camera.
2. (Optional) For cement ceiling, drill the screw holes
with a 5.5 mm drill and insert the supplied wall plugs.
3. (Optional) Drill the cable hole, when the cables are
routed through the ceiling.
4. Align the screw holes in the bracket to the ceiling, and
secure the camera with three PA4 × 25 screws
(supplied).
Screw Hole
Figure 2-8 Drill Template
Body
Screw Hole
Screw Hole
templat e