Table of Contents
Advertisement
Figure 2-13 Fit the Camera onto the Gang Box
5. Turn the camera clockwise until it snaps into the gang
box.
Figure 2-14 Snap the Camera into the Gang Box
6. Connect the power cord and video cable.
7. Power on the camera to check whether the image on
the monitor is gotten from the optimum angle. If not,
adjust the camera according to the figure below.
1). Rotate the enclosure to adjust the pan position [0°
to 360°].
2). Move the main body up and down to adjust the
tilt position [0° to 75°].
3). Rotate the main body to adjust the rotation
position [0° to 360°].
2.3.2 Ceiling Mounting with Junction Box
Before you start:
You need to purchase a junction box in advance.
Steps:
1. Loosen screws to take apart the junction box.
2. Paste the drill template for junction box to the place
where you want to install the camera.
3. (Optional) For cement ceiling, drill the screw holes
with a 5.5 mm drill and insert the supplied wall plugs.
Figure 2-16 Drill Template for Junction Box
Figure 2-15 3-Axis Adjustment
Advertisement
Table of Contents
