Table of Contents
Advertisement
Figure 2-2 Secure the Camera to the Ceiling
5. Connect the power cord and video cable.
6. Power on the camera to check whether the image on
the monitor is gotten from the optimum angle. If not,
turn the trim ring counterclockwise to loosen it and
adjust the positions according to the figure below.
Rotation Position
[0° to 360°]
7. Turn the trim ring clockwise to lock the positions.
2.1.2 Ceiling/Wall Mounting with Junction Box
Before you start:
You need to purchase a junction box in advance.
Ceiling mounting and wall mounting are similar.
Following steps take wall mounting as an example.
Steps:
1. Paste the drill template for junction box to the place
where you want to install the camera.
2. (Optional) For cement wall, drill the screw holes with
a 5.5 mm drill and insert the supplied wall plugs.
Figure 2-4 Drill Template for Junction Box
3. (Optional) Drill the cable hole, when the cables are
routed through the wall.
4. Take apart the junction box.
5. Align the screw holes of the camera with those on the
junction box cover. Attach the camera to the junction
box cover with three PM4 × 10 screws.
Figure 2-5 Attach the Camera to the Junction Box Cover
6. Secure the junction box body on the wall with three
PA4 × 25 screws (supplied).
Figure 2-3 3-Axis Adjustment
Pan Position
[0° to 360°]
Trim Ring
Tilt Position
[0° to 90°]
Advertisement
Table of Contents
