Compaq StorageWorks ESL9000 Series Installation Manual page 42

Pass-through mechanism

Hide thumbs Also See for StorageWorks ESL9000 Series:

Table of Contents

3. Install a QSPI terminator on the left QSPI connector for the left tape

library.

4. Connect one end of the interconnect cable to the right QSPI connector

on the left tape library.

5. Route the interconnect cable through the bottom of the tape library and

then connect it to the left QSPI connector on the right tape library.

6. If there are no other tape libraries in the configuration, install a

terminator in the right QSPI connector of the right tape library. If there

are additional tape libraries in the configuration, continue connecting the

tape libraries using the interconnect cable. Note that the final tape

library in the configuration will have a QSPI terminator on the right

QSPI connector.

Cabling the PTM 4-3

Table of Contents