Compaq StorageWorks ESL9000 Series Installation Manual page 35

3-14 Compaq StorageWorks Pass-Through Mechanism Installation Guide
3. Adjust the width of the top of the assembly to be 1/16 of an inch less
than the top measurement found in Step 1. This enables the cosmetic
assembly to slide in between the tape libraries for installation.
4. Tighten the nut closest to the top of the assembly to a torque value of
5-in/lb.
5. Adjust the width of the bottom of the assembly to be 1/16 on an inch
less than the bottom measurement found in Step 1.
6. Tighten the nut closes to the bottom of the assembly to a torque value of
5-in/lb.
7. Tighten the remaining nuts on the assembly to a torque value of 5-in/lb.
8. On the left and right side of the front cosmetic assembly, install two
67.5 in (171 cm) pieces of foam gasket material as shown in Figure
3-10.