Compaq StorageWorks ESL9000 Series Installation Manual page 20

2-6 Compaq StorageWorks Pass-Through Mechanism Installation Guide
9. Attach the right tape library to the lower cabinet attachment channel
with five bolts (P/N 0615113) and washers (P/N 0685521). Do not fully
tighten and allow the lower cabinet attachment channel to float freely.
10. Lower the leveling feet on both tape libraries and then level them
appropriately while maintaining the following:
I
The tape cartridge bin walls should be coplanar within 0.06 inch.
I
The front surfaces of the two tape libraries should be coplanar
within 0.25 inches.
I
The top surfaces of the two tape libraries should be flush within
0.06 inches.
11. Tighten the lower cabinet attachment channel screws in both tape
libraries to 70 in/lb.
12. Install the two spacers (P/N 6312028) and the upper cabinet attachment
plate (P/N 6312027) as shown in Figure 2-5 with seven screws and
washers on each side.