Configuring Snapshot Settings - Honeywell H4L6GR2 User Manual

Resolution
In the Resolution box, select a resolution from the list. The available options differ between
the main stream and sub streams.
Frame Rate
In the Frame Rate (FPS) box, select a frame rate within the available range (1–30 fps for
NTSC cameras; 1–25 fps for PAL cameras).
Note
Bit Rate
In the Bit Rate Type box, select CBR or VBR.
In the Bit Rate box, select a bit rate from the list using the Reference Bit Rate as a guide.
I-Frame Interval
In the I-Frame Interval box, enter a value between 1 and 150. The default I-frame interval is
two times the frame rate. For example, if the frame rate is 30 fps, the I-frame interval will be 60.
Watermark
To apply a custom watermark to the main stream, select the Watermark Settings check box.
In the Watermark Text box, enter the watermark text. The text cannot have any spaces but
underscores (_), and hyphens (-) are acceptable.
Click Save to apply the settings.

Configuring Snapshot Settings

You can configure snapshot properties on the Setup > Compression Setup > Snapshot page.
Snapshot Type
Set the Snapshot Type to General or Event.
Only 1-25fps can be selected for main resolution of HM4L8GR1 and
HMBL8GR1 in NTSC mode.
CBR Constant bit rate. The bit rate remains constant (recommended for
low-bandwidth environments). Required if MJPEG compression is used.
VBR Variable bit rate. The bit rate changes according to the complexity of the scene.
Select a Quality level between 1 (lowest quality) and 6 (highest quality).
General
Snapshots are taken according to a user-defined schedule.
Configuring Video and Audio Settings
21