Table of Contents
Advertisement
What to do upon
Unpacking the
instrument
Thermo Fisher Scientific
Chapter 3
Installation
This chapter describes the installation of the KingFisher Duo
instrument.
This section covers the relevant procedures to be carried out on receipt
of the instrument.
delivery
Move the packed instrument to its site of operation. To prevent
condensation, the instrument should be left in its protective, antistatic
plastic wrapping until the ambient temperature has been reached.
Unpack the KingFisher Duo instrument and accessories carefully with
the arrows on the transport package pointing upwards. Remove the
instrument from the package and place it on a level surface.
The following notes and instructions are sent with the instrument and
are immediately available when you open the package:
Thermo Scientific KingFisher Duo Brief User's Guide
●
BindIt™ Software installation CD
●
Caution Do not touch or loosen any screws or parts other than those
specifically designated in the instructions. Doing so might cause
misalignment and will void the instrument warranty.
Warning The KingFisher Duo weighs approximately 16 kg [35 lbs.]
without the transport package and should be lifted with care. It is
recommended that two persons lift the instrument together, taking the
proper precautions to avoid injury.
To lift the instrument, put your fingers under the bottom on either
sides and lift it with your back straight.
KingFisher Duo User Manual
•
BindIt Software for KingFisher Instruments User Manual
•
Thermo Scientific User Awareness of Symbols
•
Declaration of Conformity document
•
▲
▲
Thermo Scientific KingFisher Duo User Manual
21
Advertisement
Table of Contents
