Rear Panel; Side Panel - Watchguard AP332CR Hardware Manual

Rear Panel

Ground Connector
Use the included ground screw to attach the ground wire to the ground connector on the rear of the
access point and attach the other end of the wire to a nearby grounding point.

Side Panel

LED Indicators
The access point has LED indicators that can show status conditions for the device connection to
WatchGuard Cloud. The LED indicator status depends on the firmware version on the device.
Access Point Firmware 1.1.7-0 and Higher
Wi-Fi in WatchGuard Cloud access points that run firmware 1.1.7-0 and higher have LED indicators
that can show different status conditions while booting, activation validation, feature key download,
WatchGuard Cloud device registration, and the connection to WatchGuard Cloud.
The access point briefly passes through each stage until the device is connected to WatchGuard
Cloud and shows a solid blue LED indicator. If the access point remains in the same state for a long
period of time without a solid blue LED indicator status, there might be a network issue, activation or
feature key issue, or a problem with your WatchGuard Cloud account.
Check the following table for the status of the LED indicators and how to troubleshoot the issue.
WatchGuard Technologies, Inc.
WatchGuard AP332CR Hardware Guide
10