Table of Contents
Advertisement
Antenna Installation
The access point includes four antennas.
The access point requires two antennas for each radio.
n
On the top and bottom of the access point, there are two connectors for the 2.4 and 5 GHz radios
n
Insert the antennas into the connectors for each radio and turn clockwise to tighten.
n
The device must have antennas connected for full range and functionality.
You can use other third-party omnidirectional and directional antennas based on your deployment
requirements. If you use other third-party antenna types, you are responsible for verifying compliance
with regional-based regulations based on the peak gain values.
Connect the Ground Wire
To make sure your access point is safely protected from electrical events, we recommend you ground the
access point according to your local regulations.
Use the included screw to attach the ground wire to the ground connector on the access point and attach
the other end of the wire to a nearby grounding point.
WatchGuard Technologies, Inc.
WatchGuard AP332CR Hardware Guide
18
Advertisement
Table of Contents
