Table of Contents
Advertisement
Wall Mount Installation
Use the supplied wall-mounting accessories to install the access point on a wall.
1. Mark the location on the wall surface for the four mounting holes of the wall mounting bracket.
Use an appropriate drill bit to drill holes that are 8.1mm diameter and 26mm depth in the
n
markings and hammer the bolts into the openings.
Screw the anchors into the holes until they are flush with the wall.
n
2. Screw the included screws into the anchors.
3. Slide the mount bracket into the slot of the access point.
WatchGuard Technologies, Inc.
WatchGuard AP332CR Hardware Guide
16
Advertisement
Table of Contents
