Ranger 3DP4100 Operation Manual page 5

Do not attempt to operate this equipment if you have never been trained on basic alignment procedures / automotive lift
For your safety, read this manual thoroughly before operating the equipment. The Alignment System is intended for use
by properly trained skilled automotive technicians. The safety messages presented in this section and throughout the
manual are reminders to the operator to exercise extreme care when performing wheel alignments with this product.
It is assumed that, prior to using the Alignment System, the operator has a thorough understanding of the vehicle
systems being serviced. In addition, it is assumed he has a thorough knowledge of the operation and safety features of
the alignment rack or lift, and has the proper hand and power tools necessary to perform wheel alignments.
When using your garage equipment, basic safety precautions should always be followed, including:
1. Read all instructions and warning labels.
2. Care must be taken as burns can occur from touching hot parts.
3. Do not operate equipment with a damaged power cord or if the equipment has been dropped or damaged until it has
been examined by a qualified serviceman.
4. Do not let cord hang over edge of table, bench or counter or come in contact with hot manifolds or moving fan
blades.
5. If an extension cord is necessary, a cord with a current rating equal to or more than that of the equipment should be
used. Cords rated for less than the equipment may overheat. Care should be taken to arrange the cord so that it will
not be tripped over or pulled.
6. Always unplug equipment from electrical outlet when not in use. Never use the cord to pull the plug from the outlet.
Grasp plug and pull to disconnect.
7. DO NOT TURN POWER OFF when the computer is running, this can destroy the software.
8. Let equipment cool completely before putting away. Loop cord loosely around equipment when storing.
9. To reduce the risk of fire, do not operate equipment in the vicinity of open containers of flammable liquids, such as
gasoline.
10. Adequate ventilation should be provided when working on operating internal combustion engines.
11. Keep hair, loose clothing, fingers, and all parts of body away from moving parts.
12. To reduce the risk of electrical shock, do not use on wet surfaces or expose to rain.
13. Use only as described in this manual. Use only manufacturer's recommended attachments.
14. ALWAYS WEAR SAFETY GLASSES. Everyday eyeglasses only have impact resistant lenses, they are NOT safety
glasses.
operation.
IMPORTANT SAFETY INFORMATION
IMPORTANT
SAVE THESE INSTRUCTIONS
DO NOT DISCARD
5