Installing Clamps - Ranger 3DP4100 Operation Manual

Make sure the vehicle has been checked for the following:
1. All wheel rims and tires should match and tires should be
the same size.
2. Tread pattern should not be worn and all tires should
have the correct manufacturer's specified air tire pressure.
3. Inspect and qualify condition of suspension components.
4. Gap between gear and steering lever (steering wheel
play).
5. Wheel rim offset.
6. Vehicle is properly loaded side to side..
7. Shake vehicle to allow suspension return to rest position.
8. Make sure the pins of turntable and slide slip insert cor-
rectly. The pins can't take out until the vehicle drive on the
turntable and slide slip.
9. Install the pedal locker correctly.

Installing Clamps

Install the clamps and targets on the wheel rim. Turn the
center knob of the clamp to adjust its size to be suitable for
rim. Make sure the 4 claws of the clamp stick to the wheel
rim closely. Turn the knob of the clamp to fix it on the wheel
tightly.
TO PERFORM A FOUR WHEEL ALIGNMENT
MEASUREMENT, TECHNICIAN SHOULD
INSTALL ALL FOUR TARGETS FOLLOWING
DIRECTIONS: (TWO FRONT TARGETS, TWO
REAR TARGETS). TWO WHEEL ALIGNMENT
MEASUREMENT: IT ONLY NEEDS TO
INSTALL TWO FRONT TARGETS.
NOTE:
HOMEPAGE AND MENUS
Software program homepage is the beginning of mea-
surement, there are two measurement ways: four wheel
alignment, two wheel alignment. The operator can begin to
measure after choosing new vehicle specification or after
entering history customer information.
Settings
Exit
MENU EXPLANATION
Vehicle Specification Screen Buttons
Search Targets Screen Buttons
Adjust Camera
Exposure
17
Homepage
Customer Information
Selection
Choose Vehicle
Search Targets
Manually
Search Targets
Manually
Specification
Close