Cameras And Target Position; Adjusting Camera Beam; Camera Led Indicators - Ranger 3DP4100 Operation Manual

Cameras and Target Position

Make sure the cameras and all four targets are pointing in a
relative position and within the camera view field, otherwise
it will affect the measurement precision.
Automatic Lifting Camera Beam
The camera will trace the targets automatically and the
camera beam will follow the targets to adjust the correct
position; it can also be adjusted using the keyboard or
mouse. (NO< NO< NO)
Target Status
Operator will be able to see on the screen if all targets are
positioned in the correct camera view field by the colors
displayed on the screen. Blue and green mean the targets
are on the correct position and within the camera view field.
Yellow means the targets are off the camera view field and
out of the measurement range, the targets position should
be adjusted. Solution: Move camera crossbeam until targets
are correct color.
When installed correctly, the front targets will appear blue
on the screen and the rear targets will show green. (See
pictures below).

Adjusting Camera Beam

Fixed Camera Beam
Raise lift to proper height and position it on the locks. Unlock
fixed knobs on the camera crossbeam, run the software
program to target searching screen, adjust the camera
beam position according to the targets image on the screen.
When you see the front targets are blue and the rear targets
are green means the camera beam position is within
tolerance.
Explaining Camera LED Indicators
The LED indicators on the right and left camera beam
represent the four target status. Four LED indicators in red
means the targets are stopped or immobile, if the LED
indicator is red and flickering, this means the
corresponding target is blocked (line of sight), not working
correctly or not recognized by the system for any reason, as
illustrated below.
Left Front
Left Rear
15
Right Front
Right Rear