Table of Contents
Advertisement
8.2.2 TID
Our 3D alignment products use the real time TID calculation technology during the measurement, so
the customer doesn't need to do TID after equipment installlation. But it must make once TID if the
customer wants to choose "super measurement" way.
It needs to istall the clamps with targets together after equipment installation, also use tool to fix the
clamps and targets. Then clamp the four clamps with targets on the four wheels tightly, make sure
the claws of the clamps stick to rim of the wheel very closely. Run wheel alignment software program,
choose "TID" on camera calibration screen.
NOTE:
1. Make sure the claw of the clamp must stick to the rim of the wheel very closely and tightly.
Because it is the important element to guarantee the precise measurement.
2. If the customer chooses the "super measurement" function, it must make once TID after
equipment installation, make sure the clamps with targets always fix together after TID. It needs
to make TID again if the clamps and targets separate, or will affect the measurement precision.
Other measurement ways don't need to do TID, also clamps and targets can separate.
Click "TID" located on the left side of the screen, and then enter TID.
115
Advertisement
Table of Contents
