Table of Contents
Advertisement
Preparation Before Alignment
Before starting wheel alignment and placing vehicle onto the
lift, the following inspection should be done on the Approach
Camera to make sure it has been activated.
1. Click "camera" icon located on the lower left side on the
homepage.
2. Remove camera cover. If you forget to take off the cover
you will not be able to see the vehicle approaching the
ramp.
3. If view is out of focus, loosen the camera fixed screw
with a Phillips screwdriver.
4. Use hand to turn the outside of lens slowly untill you
notice the image is clear. Turn clockwise or counter
clockwise to adjust as necessary.
5.
After the camera lens has been adjusted, drive the
vehicle onto the lift, ensure that the front wheels are
centered with the turntables. Apply the hand brake to make
sure the car will not move. To prevent the turntables from
turning, lock the turntables with their respective lock pins
before driving the vehicle. You will be able to see the vehicle
on the screen.
13
APPROACH CAMERA
Advertisement
Table of Contents
