3. Check vehicle specification that was inputted as shown in the image below. Next drag the tool bar
to theend to find the information that was just inputted.
NOTE:
1. When entering vehicle specification. If the number is positive, it DOES NOT need to input
"+" symbol with number. If the number is negative, it MUST input "-" symbol with number to-
gether.
2. When entering the number, it MUST input complete. For example: the number on the book is
".09", you must input "0.09", CAN NOT only input ".09".
3. When entering vehicle specification, we require to input by degree unit. So if the vehicle
specification on the book is inch, you need to calculate from inch to degree. The calculation formula is:
degree=inch*25.4*2.257/rim diameter
4. Degree=minute/60
128