Table of Contents
Advertisement
8.2.1 RCP
RCP is one of the ways to calibrate the relationship between left
camera and right camera. The customer need to purchase special 3D
calibration bar from factory if want to do RCP of wheel alignment.
Calibration bar installation:
Screw the M6 set screws in the calibration bar, move the calibration
bases from two sides, use inner set screws to locate, then screw in the
set screws to locate the calibration base, at last, screw the M8 knobs to
the corresponding position. See below photo for reference.
8.2.1.1 Confirm the targets position
1. Operator must trace the targets to confirm the targets position. Use
rear targets as calibration target. So put the calibration bar with two rear
targets on 1m position behind the center of turntable, the center of the
targets must be parallel with camera beam, also the targets must be
vertical to the ground, then lock the calibration bar tightly. Can click
animation help for reference.
2. Operator can choose close "automatic exposure time calculation"
during calibration procedure, and change as adjust the gray values of
101
Advertisement
Table of Contents
