Table of Contents
Advertisement
Preparation for Measurement Before Runout Compensation
Make sure there are no obstacles blocking the targets when starting the measurement process.
On the "Preparation for Measurement" screen, click on the car icon, located at the lower center of the
screen, you will be prompted to the next screen titled "Search Targets".
Here, you will click on the tower icon. Visual instructions will display showing the operator if the next step is
either to lower or rise the arms of the 3D Aligner.
Follow the instructions given until all targets reach the same value of 255 or close to this value and the
colors from the left and right side targets are exactly the same all the way around. (If the operator is not
able to get one of the values, possibly something is blocking one of the targets and disturbing the whole
process).
Click X to close this screen. Operator will be taken back to the "Preparation for Measurement" screen.
Now, click on the forward arrow to go to the next step, screen auto-adjusts.
Next is "Conventional Runout Compensation", on this selection, push or pull back the vehicle slowly to the
direction indicated by the green arrow shown on the screen. Follow directions until the countdown from 10
reaches 0. When the "STOP" sign displays, operator must stop pushing or pulling back the vehicle
immediately and wait for the next indication. Click X to close this screen.
On the "Preparation for Caster Measurement" selection
36
Advertisement
Table of Contents
