Definitions Of Hazard Levels - Ranger 3DP4100 Operation Manual

BEFORE YOU BEGIN
NOTIFY THE CARRIER AT ONCE if any hidden loss or
damage is discovered after receipt and request the carrier
to make an inspection. If the carrier will not do so, prepare
a signed statement to the effect that you have notified the
carrier (on a specific date) and that the carrier has failed to
comply with your request.
IT IS DIFFICULT TO COLLECT FOR LOSS OR DAMAGE
AFTER YOU HAVE GIVEN CARRIER A CLEAR RECEIPT.
Support claim with copies of the bill of lading, freight bill,
invoice, and photographs, if available. BendPak's
willingness to assist in helping you process your claim does
not make BendPak responsible for collection of claims or
replacement of lost or damaged materials.
IMPORTANT NOTICE
Do not attempt to install this machine if you have never
been trained on basic automotive service equipment
installation procedures. Never attempt to lift components
without proper lifting tools such as a forklift or cranes. Stay
clear of any moving parts that can fall and cause injury.
These instructions must be followed to ensure proper
installation and operation of your 3D Pro wheel aligner.
Failure to comply with these instructions can result in
serious bodily harm and void product warranty.
Manufacturer will assume no liability for loss or damage
of any kind, expressed or implied resulting from improper
installation or use of this product.
PLEASE READ ENTIRE MANUAL
PRIOR TO INSTALLATION
OWNER'S RESPONSIBILITY
To maintain equipment and user safety, the responsibility
of the owner is to read and follow these instructions:
t
Follow all installation and operation instructions.
t
Make sure installation conforms to all applicable Local,
State, and Federal Codes, Rules, and Regulations;
such as State and Federal OSHA Regulations and
Electrical Codes.
t
Carefully check the equipment for correct initial function.
t
Read and follow the safety instructions. Keep them
readily available for machine operators.
t
Make certain all operators are properly trained, know
how to safely and correctly operate the unit, and are
properly supervised.
t
Allow unit operation only with all parts in place and
operating safely.
t
Carefully inspect the unit on a regular basis and
perform all maintenance as required.
t
Service and maintain the unit only with authorized or
approved replacement parts.
t
Keep all instructions permanently with the unit and
all decals on the unit clean and visible.
DEFINITIONS OF
HAZARD LEVELS
Identify the hazard levels used in this manual with the
following definitions and signal words:
Watch for this symbol as it means: Immediate hazards
which will result in severe personal injury or death.
Watch for this symbol as it means: Hazards or unsafe
practices which could result in severe personal injury or
death.
Watch for this symbol as it means: Hazards or unsafe
practices which may result in minor personal injury,
product or property damage.
INSTALLER / OPERATOR
PROTECTIVE EQUIPMENT
Personal protective equipment helps makes installation
and operation safer, however, it does not take the place
of safe operating practices. Always wear durable work
clothing during any installation and/or service activity.
Shop aprons or shop coats may also be worn, however
loose-fitting clothing should be avoided.
Tight-fitting leather gloves are recommended to protect
the technician's hands when handling parts. Sturdy
leather steel-toe work shoes and oil resistant soles should
be used by all service personnel to help prevent injury
during typical installation and operation activities.
Eye protection is essential during
installation and operation
activities. Safety glasses with
side shields, goggles, or face
shields are acceptable. Back
belts provide support during
lifting activities and are also helpful in providing worker
protection. Consideration should also be given to the use
of hearing protection if service activity is performed in an
enclosed area, or if noise levels are high.
4