Dog trace d-control 640 Manual page 11

Button - Vibration
By pressing this button, you will send a warning to your dog in the form of vibration. There are 5 modes
of vibration available.
Mode
Mode setting is done using buttons (vibration mode setting) on the remote controller. Transmission
symbol appears on the remote controller LCD display. A red LED diode on the receiver is lit permanently.
Button – lighting the collar
A red LED diode inbuilt in the collar emits very intensive flashes which are stronger than by common light
collars. Your dog can be easily located even in absolute darkness! There are 8 interesting flashing modes
available.
Mode
0
1
2
3
4
5
6
7
32
Vibration mode selection
Function
0
short vibration
1
vibrates as long as you keep the button pressed
2
series of interrupted vibrations
3
vibrates interruptedly as long as you keep the button pressed
4
vibrates permanently and releases a sound signal
Light mode selection
Function
pressing shortly - single blink
pressing permanently - blinking as long as the button is pressed
pressing shortly - blinking 10times
after pressing - a blink in every 5 seconds
same function as mode 0 with a different flashing frequency
same function as mode 1 with a different flashing frequency
same function as mode 2 with a different flashing frequency
same function as mode 3 with a different flashing frequency