Serial Port Specifications; Serial Port Connectors - HP StorageWorks SAN Switch 2/32 Installation Manual

Serial Port Specifications

The Serial port can be used to connect to a computer workstation to configure the
switch IP address without connecting to the fabric. The Serial port's parameters are
9600 baud, 8 data bits, no parity, 1 stop bit, and no flow control.
The port requires a straight Serial cable with a female 9-pin subminiature-D
connector. Only pins 2, 3, and 5 are supported; if pin 7 is used, the signal must always
be driven high, using the pinouts listed in Table A–4.
Table A–4: Serial Port Connectors
PIN Signal
1
2 TxData
3 RxData
4
5 GND
6
7
8
9
NOTE: For dust and ESD (electrostatic discharge) protection, a cover is provided for the Serial
port and should be kept on the port whenever the Serial port is not in use.
SAN switch 2/32 version 4.0.x installation guide
Description
Transmit Data
Receive Data
Logic Ground
Technical Specifications
A–5 A–5