U-Line H-6067 Quick Start Manual

π
H-6067
BULK SOAP DISPENSERS

OPENING THE DISPENSER

1. To open the dispenser lid, push in the button on the
bottom of the back of the dispenser.
2. Back lid will pop off. (See Figure 1)
Figure 1

GENERAL MOUNTING INSTRUCTIONS

• Use the included tape on glazed tile, painted metal
or unpainted metal walls. Tape will not work well if
wall surface is porous, like brick or wood.
• On all other wall surfaces, use screws and anchors
(included) or other appropriate hardware based on
surface type.
• Install dispenser above a sink or counter. Never
install where spillage can fall on floor creating
hazardous conditions.
• Installer will be held responsible for proper

installation.

• To be in compliance with ADA regulations, the
dispenser should be mounted no more than 48"
from the ground.
PAGE 1 OF 6
1-800-295-5510
uline.com
INSTALLATION

MOUNTING WITH DOUBLE-SIDED TAPE

1. Thoroughly clean wall surface and let dry
completely. For silicone buildup, use a pumice-type
cleaner or grout cleaner to clean the surface.
2. Peel off paper from back of tape (included). Press
dispenser firmly to wall and hold for at least 30
seconds to make sure tape has completely adhered
to wall. (See Figure 2)
3. Wait 24 hours before filling with soap to ensure that
the tape has completely adhered to wall.

MOUNTING WITH SCREWS AND ANCHORS

1. Remove lid. Push down on back plate and detach
dispenser from back plate.
(See Figure 3)
2. Using the back plate as a template, mark hole
locations on wall.
3. Drill 3/16" diameter holes for anchors and screws or
other hardware. Attach dispenser to back plate and
replace lid.
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
Figure 2 Figure 3
0819 IH-6067