Page 1
π H-878 1-800-295-5510 uline.com PLASTIC TOILET SEAT COVER DISPENSER TOOLS NEEDED Drill Drill Bit Phillips Screwdriver Level PARTS Adhesive Strip x 3 (already attached) Dispenser x 1 MOUNTING INSTRUCTIONS - ADHESIVE STRIPS NOTE: Ensure that proper mounting hardware Remove backing from adhesive strips.
Page 2
MOUNTING INSTRUCTIONS - SCREWS NOTE: Screws are not included with dispenser. 2. Drill into wall at two marked locations with appropriate-sized drill bit. Insert wall anchors if necessary. (See Figure 3) Hold dispenser up to desired location and mark two holes on the wall where screws will be inserted.