4 - Sprayer setup
Filling the fuel tank
The fuel tank has a 320-litre capacity. Before filling, shut down the engine and do not smoke. Clean the plug (1) carefully so
that no impurities can enter the tank. Use a funnel if necessary.
÷
NOTE! Before a prolonged stop, we recommend filling the tank to avoid condensation.
÷
NOTE! The electronic fuel injection engine complies with the TIER3 B standard. Fuel that complies with the standards
in force should therefore be used.
Spray pump
• Screw the 2 plugs (1) to the diaphragm pump.
CycloneFilter
The filter is 80 mesh as standard. However, you can use different sized filters, such as 50 or 100 mesh if necessary. Check the
condition of the seals, grease and lubricate them if necessary before refitting them.
Fitting the nozzles
To choose the correct nozzle for use and to achieve optimum spray quality according to the restrictions of the application
and environment, see the SPRAY TECHNIQUES book and Also see section "Nozzles chart" page 109
• Place the nozzle filter (1) in the nozzle nut (2)
• Fit the nozzles equipped with their filters to the nozzle holder, by
turning the nut a 1/4 turn.
48
1
1
1
1
1
2
2
2