Table of Contents
Advertisement
2 - Safety instructions
Usage
€
Carry out a pressure test with clean water prior to filling with chemicals. Never dismantle the hose while the sprayer
is in operation.
DANGER! Do not exceed the maximum recommended rotation speed of the pump.
€
Rinse and wash the equipment after use and before servicing.
€
Never service or repair the equipment while it is operating. Always replace all safety devices or shields immediately
after servicing or repair.
€
Disconnect the electrical power before servicing and depressurise the equipment after use and before servicing.
€
If an arc welder is used and connected to any part of the sprayer, disconnect the power leads from the battery before
welding. Remove all inflammable or explosive material from the welding area.
€
The External Cleaning Device should not be used if important parts of the equipment have been damaged, including
safety devices, high pressure hoses etc.
€
Take all precautions to avoid the risks related to unintentional contact with overhead power lines. A sticker placed
near the operator's seat warns of the risk of contact with overhead power lines.
±
The volume in the tank must never exceed the Gross Vehicle Weight (GVW) allowed.
You must take into consideration the volume in the tank will be adjusted according to the density.
Sprayer usage
This HARDI EVRARD self-propelled sprayer is exclusively intended for use in farming work, i.e. the application of plant
protection chemicals and liquid fertilisers.
Any other use is considered contrary to normal usage and is therefore forbidden.
Operator's skill
The machine should be used and maintained by people who are aware of its special use and safety characteristics.
Before using your machine, familiarise yourself with all the commands. When working it will be too late to do so.
Ensure that you have the skills required for protecting crops and the environment, and for handling and spraying plant
protection chemicals. For more information about personal and environmental protection, see the SPRAY TECHNIQUES
book.
Definition of the working place
Never leave the operator's seat when the machine is moving.
The following is considered as the working place:
1. the outside area where the valves are located that can be handled during tank filling and liquid preparation operations
2. the operator's seat
3. the access ladder and the footboard for accessing the tank opening
12
Advertisement
Table of Contents
