Vertical Alignment Of Outer Sections 1 And 2 - Hardi COMMANDER DELTA FORCE Instruction Book

6 - Maintenance

Vertical Alignment of Outer Sections 1 and 2

Steps for adjustment:
1. Start with outer section 1, which is aligned with the inner section.
2. At the top of the boom, the nuts (A,B) are turned.
Wrench size = 41 mm.
Raise the boom: Loosen (A), tighten (B).
Lower the boom: Loosen (B), tighten (A).
3. At the bottom of the boom, the ram eye (C) can be adjusted, if
needed. Remove the black pin (D), loosen the counter nut (E) and
turn the ram eye 180°. Tighten the counter nut and refit the black
pin. Check alignment of the boom section.
4. When outer section 1 is aligned, tighten the counter nuts.
Adjustment is completed when the alignment is straight, and the
folding is trouble-free.
5. Now the outer section 2 is aligned with outer section 1 in the same
way by completing steps 2 - 4.
164
A A
B B
C
D
E