Operating The Turbofiller - Hardi COMMANDER DELTA FORCE Instruction Book

Operating the TurboFiller

The TurboFiller is where you add the chemicals to be mixed with water in the main tank.
Capacity: approximately 35 litres.
Before Use
• Push the handle (A) to unlock the position of the TurboFiller.
• Grab the handle above and pull the TurboFiller towards you.
• Lower the TurboFiller, until it clicks into the locked position.
• Unlock the lid (B) in the left side and open it fully.
• Place the chemicals for the coming spray job here ready to be filled
into the TurboFiller.
After Use
• Clean the inside of the TurboFiller with the spray gun to remove
chemical residues.
• Place the spray gun in its storing position (C).
• Close the lid on top of the TurboFiller and lock it in the left side.
• Grab the handle above and push the TurboFiller upwards.
• Push the TurboFiller back in storage position, until it locks.
μ
ATTENTION! When unlocking the TurboFiller, always keep a hand
on the handle to avoid abrupt movement of the TurboFiller!
On the next page is a short description on how to operate the valves by using the levers on the side of the TurboFiller.
For more details, see the following sections in this Instruction Book about the procedure for operating the TurboFiller while
filling chemicals.
5 - Operation
105