Installing The Cylinder Head Cover - Yamaha XSR MTM690 2016 Service Manual

1
EAS30274

INSTALLING THE CYLINDER HEAD COVER

1. Install:
• Timing chain guide (top side)
• Cylinder head cover gasket "1"
(to the cylinder head cover)
• Cylinder head cover "2"
Cylinder head cover bolt
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
TIP
• Apply Yamaha bond No.1215 "3" onto the mat-
ing surfaces of the cylinder head cover gasket
and cylinder head.
• After installing the cylinder head cover gasket
"1" to the cylinder head cover, cut off the "a"
section.
• Make sure that the projection "b" on the cylin-
der head cover gasket is positioned on the ex-
haust side of the rib "c" on the cylinder head
cover.
Yamaha bond No. 1215
90890-85505
(Three bond No.1215®)
a
2
New
3
1
New
c
b
A
A. Exhaust side
2. Install:
• Spark plugs
• Ignition coils "1"
TIP
Install the ignition coils "1" in the direction shown
in the illustration.
3
2
5-22
CAMSHAFTS
Spark plug
13 Nm (1.3 m·kgf, 9.4 ft·lbf)
1
1 New
2