Installing The Connecting Arm; Installing The Swingarm - Yamaha XSR MTM690 2016 Service Manual

3. Check:
• Collar
Damage/scratches → Replace.
EAS31114

INSTALLING THE CONNECTING ARM

1. Lubricate:
• Spacers
• Bearings
Recommended lubricant
Lithium-soap-based grease
2. Install:
• Bearings "1"
• Oil seals "2"
New
(to the connecting arm "3")
TIP
When installing the oil seals to the connecting
arm, face the character stamp of the oil seals
outside.
New
3
A
A. Left side
B. Right side
Installed depth "a"
3.5–4.5 mm (0.14–0.18 in)
Installed depth "b"
8.0–9.0 mm (0.31–0.35 in)
3. Install:
• Spacer
• Connecting arm
• Connecting arm bolt "1"
• Connecting arm nut
Connecting arm nut (frame side)
52 Nm (5.2 m·kgf, 38 ft·lbf)
TIP
Align two flat sides "a" of the connecting arm bolt
with the projections "b" on the frame.
2 2 New
a
1
b
EAS30228

INSTALLING THE SWINGARM

1. Lubricate:
• Collar
• Pivot shaft
• Bearings
Recommended lubricant
2. Install:
• Bearings "1"
• Oil seals "2"
(to the swingarm)
Installed depth "a"
B
Installed depth "b"
Installed depth "c"
Installed depth "d"
TIP
Install the oil seals to the swingarm so that they
are facing in the directions shown in the illustra-
tion.
4-91
SWINGARM
b
1
a
Lithium-soap-based grease
New
3.0 mm (0.12 in)
1.0 mm (0.04 in)
9.0 mm (0.35 in)
15 mm (0.59 in)