Yamaha XSR MTM690 2016 Service Manual page 95

1. Throttle cable (accelerator cable)
2. Throttle cable (decelerator cable)
3. Intake air pressure sensor
4. Intake air pressure sensor hose
5. Fuel hose
6. Air filter case
7. Throttle body assembly
8. Cylinder head breather hose
A. Install the intake air pressure sensor hose up to
the bend in the hose fitting of the intake air
pressure sensor.
B. Make sure that the hose is not twisted.
C. Install the intake air pressure sensor hose onto the
throttle body assembly, making sure that the hose
contacts the throttle body assembly.
D. Forward
E. Face the yellow paint mark on the cylinder head
breather hose to the left. Install the cylinder head
breather hose completely onto the hose fitting.
F. Position the hose clamp 1
from the end of the hose. Point the ends of the
hose clamp to the left.
G. Position the hose clamp 1
from the end of the hose.
°
H. 90
I. Position the ends of the hose clamp within the
range shown in the illustration.
J. Face the blue paint mark on the cylinder head
breather hose upward. Install the cylinder head
breather hose onto the air filter case, making sure
that the hose contacts the case.
– –
4 mm (0.04 0.16 in)
– –
4 mm (0.04 0.16 in)
2-66
CABLE ROUTING