Yamaha XSR MTM690 2016 Service Manual page 410

Fault code No. P0030
TIP
• If fault code numbers "P0030" and "P0112" are both indicated, take the actions specified for fault code
number "P0112" first.
• If fault code numbers "P0030" and "P0113" are both indicated, take the actions specified for fault code
number "P0113" first.
• If fault code numbers "P0030" and "P0122" are both indicated, take the actions specified for fault code
number "P0122" first.
• If fault code numbers "P0030" and "P0123" are both indicated, take the actions specified for fault code
number "P0123" first.
Fault code No.
Item
Fail-safe system
Diagnostic code No.
Tool display
Procedure
Probable cause of malfunc-
Item
tion and check
1 Connection of O
pler.
Check the locking condition of
the coupler.
Disconnect the coupler and
check the pins (bent or broken
terminals and locking condition
of the pins).
P0030
O sensor heater: defective heater controller detected.
2
Able to start engine
Able to drive vehicle
—
—
—
Improperly connected → Con-
sensor cou-
2
nect the coupler securely or re-
place the wire harness.
FUEL INJECTION SYSTEM
Maintenance job
8-39
Confirmation of service com-
pletion
Turn the main switch to "ON",
and then check the condition of
the fault code using the mal-
function mode of the Yamaha di-
agnostic tool.
Condition is "Recovered" → Go
to item 6 and finish the service.
Condition is "Detected" → Start
the engine, and then check the
condition of the fault code.
Condition is "Recovered" → Go
to item 6 and finish the service.
Condition is "Detected" → Go to
item 2.
TIP
For this check, also set the en-
gine stop switch to "ON".