5
Using the Cutting-Unit
Kickstand
Parts needed for this procedure:
1
Cutting-unit kickstand
Procedure
Whenever you tip the cutting unit to expose the
bedknife/reel, prop up the rear of the cutting unit with
the kickstand to make sure that the nuts on the back
end of the bedbar adjusting screws are not resting on
the work surface
(Figure
Figure 22
1. Cutting unit kickstand
Secure the kickstand to the chain bracket with the
snapper pin
(Figure
23).
22).
1. Chain bracket
2. Snapper pin
6
Greasing the Machine
No Parts Required
Procedure
Before operating the machine, apply grease to ensure
proper lubrication. Refer to
g003985
Failure to properly grease the machine will result in
premature failure of critical parts.
18
Figure 23
3. Cutting-unit kickstand
Lubrication (page
g004144
39).