Before The Installation - Circontrol Post eVolve Series Installation Manual

Before installation
E L E C T R I C A L W I R I N G C O N S I D E R AT I O N S
Take into consideration this section before starting wiring
the connections of the Charge Point.
1 — E L E C T R I C A L P R O T E C T I O N S
Charge Point may not include elements of electrical protection.
If this equipment has internal electrical protections, they are installed for each socket-outlet for
the protection of the user against an electrical failure, according to the international standard
IEC 61851-1:2017.
In order to guarantee the total protection of the users and the installation (power supply line
included) in front of any electrical hazard, it is mandatory to install a main circuit breaker (MCB)
and a residual current device (RCD) upstream of the charger.
These electrical protections and the rest of the installation have to be aligned with the local and
national rules. The selectivity of the protections has to be guaranteed at all times.
2 — P O W E R S U P P LY L I N E D I M E N S I O N I N G
The dimensioning of the input power supply line of the Charge Point shall be checked by a
qualified electrician. Note that various factors such as cable length between distribution board
and Charge Point and maximum output current of the Charge Point may have influence on the
selected cable.
In such cases, increasing the cable cross-section is required to adapt the temperature resistance
of the power supply line.
3 — M A X I M U M O U T P U T C U R R E N T
Please refer to the TECHNICAL DATA section to consult the default factory settings of maximum
output current of the Charge Point.
If the power supply is less than maximum output current and adjustment to a lower nominal
current needs to be performed, please refer to the INSTRUCTION MANUAL.
Depending of the model this value may vary.
05