Setting Up The Meter Using The Push Buttons; Navigating Menus - E-Mon Din-Mon D5 Installation Instructions Manual

DIN-MON™ SMART METER
7.0 SETTING UP THE METER USING THE
PUSH BUTTONS
The meter has 4 push buttons (MENU, SELECT, UP, DOWN) located on the front of
the meter. These buttons are used to program the following items:
Item Function
1 Date and Time
2 Device ID
3 IP Settings
4 Pulse Value
5 Protocol
6 Baud Rate
7 Phase Loss
8 CT Selection
9 Access Protect
10 Change Password
11 BACnet Settings
12 Reset KW/KWH Read

7.1 Navigating Menus

Enter the main menu by pressing MENU. Continue pressing UP and DOWN until the
arrow points to desired item, then press SELECT to proceed to submenu. Use UP or
DOWN to make changes, press SELECT to advance to the next field. Press MENU to
return to main menu. If changes were made, you'll be asked to save, press UP or
DOWN to select 'Y' or 'N'; press SELECT to proceed returning to main menu. In main
menu, select EXIT to get out of programming mode and return to normal display mode.
NOTE: Hold SELECT for 3 seconds to cancel program mode, or wait for 8 seconds for
timeout to cancel.
NOTE: To change a numeric field one digit at a time, follow these steps.
1. Locate the number to be changed by using UP or DOWN.
2. Press and hold the DOWN for 3 seconds, then release the button; the last digit
for this number will blink.
3. Press UP to cycle through 0 to 9.
4. Press DOWN to move to the next digit.
5. Press SELECT to accept the changes and advance to the next field.
The submenu items that can be changed by digit:
IP address/Gateway/Subnet Mask, BACnet Device ID, BACnet MSTP MAC
Address/max masters, Pulse Value
62-0442—05
Set month, day, year, and time
Set EZ7 ID, Modbus ID, BACnet Device Instance
Set DHCP or static IP address
Output pulse values
Set protocol if D5 dual protocol meter is ordered
Set RS-485 baud rate
Set Phase Loss or VAR-hour
Set current sensor type and size
Enable/disable menu protection and/or remote
access protection
Password protection for menu items
Only applies to BACnet MS/TP
Reset Peak kWh and/or kWh readings
38
Description