Co Line Testing; Message Mode; Remote Called Station Message Mode; Remote Calling Station Message Mode - Toshiba STRATA DK24 Manual

REMOTE ADMIN & MAINT PROCEDURES
SECTION 200-096-600
FEBRUARY 1991
IMPORTANT! 11 .lO Remote Called Station Message Mode
Any electronic telephone button can be
activated from the remote terminal at any
time while in the Test Mode (even while the
end user is using the electronic telephone).
Therefore, caution must be used toprevent
service interruption or interference. The
Test Mode provides status tests to check
whetherornotastationorCOlineisinuse.
The status checks should always be made
before performing other tests.
11 .I 1
Allows the terminal to set a Called Station
Message for an originating station with the destina-
tion of the message being a station or group of
stations.
11 .I
2 When the message is set, the MW/FLLED(s)
on the destination station(s) flash.
10.10 CO Line Testing
11 .I
3 When a destination station calls the originat-
ing station, the message is displayed on the desti-
nation station's LCD.
10.11
To test CO line transmission, two or three
CO lines must be available at the remote site (see
Figure 5).
10.12
CO line testing is accomplished by using all
of the following three methods:
Mode 94:
To edit and/or review a Called Station
Message before setting it, use this mode. It will
print out the existing message and allow addi-
tions to it (such as a time or a date) before it is set.
(The message cannot be changed with this
mode-just added to.)
1)
2)
3)
Call station B at the remote site via the STRATA
system and then place the line on hold (trans-
mission is checked at the remote site via
MOH).
Establish a talk path between the two remote
stations (B & C) via a CO-to-CO connection
through STRATA.
Establish a talk path between a remote station
and the time or weather service via a CO-to-
CO connection through STRATA.
10.13
The procedures in the tables provide ex-
amples of the types of tests and functions that can
be accomplished with the Test Mode. These proce-
dures do not cover all the possible tests that can be
performed remotely; however, by using the prin-
ciples given, other tests are possible.
11 MESSAGE MODE
11 .OO General
11 .Ol
This mode allows a local or remote terminal
to set Called and Calling Station LCD messages for
station users. The messages may be system or
station type and are stored in their respective
memory locations when set.
Mode
96: To add or change a Called Station Mes-
sage before setting it, use this mode. It does not
display the existing message, but allows a com-
pletely new message to be entered before it is
set.
11.20 Remote Calling Station Message Mode
11.21
Allows the terminal to set a Calling Station
Message for a station. The message will be set on
the station's LCD and is automatically displayed on
other stations' LCDs whenever they call that sta-
tion.
Mode
95: To edit and/or review a Calling Station
Message before setting it, use this mode. It will
display the existing message and allow additions
to it (such as a time or adate) before it is set. (The
message cannot be changed with this mode-
just added to.)
Mode 97:
To add or change a Calling Station
Message before setting it, use this mode. It does
not display the existing message, but allows a
completely new message to be entered before it
is set.
11.22
Use the procedures in the tables to set
messages via Modes 94/96 and 95/97.
-9-