Exclusive Hold - Toshiba STRATA DK24 Manual

GENERAL INFORMATION
LED INDICATIONS
CO INCOMING CALL
A slow flash rate (i/2-sec. on-l/2-sec. off) indicates the CO/
PBX line on which the call is ringing.The line's LED will be red on
all stations with this button.
CONFERENCE
Avery fast flash rate (10 impulses per second (IPS)) indicates the
CO line presently in the Conference mode. Other stations' LEDs
also show a steady (busy) indication for these lines. The line LED
of the digital telephone that initiates the conference will be green.
All other stations' LEDs will be red.
EXCLUSIVE HOLD
A very fast flash rate (10 IPS) indicates the CO line is placed on
Exclusive Hold at the holding station. The LED is on steady
(busy) on all other stations. The holding station's LED will be
green, and other stations' LEDs will be red.
FLEXIBLE FEATURE BUTTON ACCESS
The LED of a flexible feature button (such as m, m,
m, etc.) will be red at the station that activated it. Stations
do not share these buttons with each other; therefore, other
stations' LEDs will not be affected.
HOLD RECALL
A quick flash rate matching the tones (2 IPS for 1 sec.-l 0 IPS
for 1 sec.) reminds a station which line has been on hold for the
programmed period of time. The line LED of the holding station
will be green during Hold Recall. All other stations' LEDs will be
red.
INTERCOM CALL
A pulsating on/off flash rate (IO IPS for 1 sec. on-l sec. off)
appears on the INT LED at the station that is being called. The
INT LEDsof the called and calling stations will be green during
the ring state and the conversation. Both stations' MIC and
SPEAKER LEDs will be red.
GENERAL INFORMATION
LED INDICATIONS (continued)
IN-USE
A steady, double flash rate (2 sec. on-l/8-sec. off-l/8-sec.
on-l/8-sec. off) indicates the CO line presently in use at the
station that originated the call. Other stations' LEDs are on
steady for that time. The line LED will be green at the station that
is participating in the CO call. Other stations' LEDs will be red.
ON-HOLD
A fast (4 IPS) flash rate (l/8-sec. on-l /8-sec. off) indicates the
CO line placed on hold at the station. The LEDs of the CO line on
hold flash at a medium rate (3/4-sec. on-l/4-sec. off) at the
other stations. If using the Pooled Line button, the hold indication
is only at the station that places the call on hold. The line LED will
be green at the station that placed the call on hold. All other
stations' LEDs will be red.