Using The Remote Control For Operating Jvc's Audio/Video Components - JVC RX-80PGD Instructions Manual

Using the Remote Control for Operating JVC's Audio/Video Components

RM-SR80U REMOTE CONTROL
TV VCR DVD AUDIO
POWER POWER MULTI POWER
VIDEO1 VIDEO2 VCR1 TAPE/VCR
TV FM/AM CD PHONO
SOUND
DELAY CNTR
DVD
MENU
1 2 3
CD
TEST ENTER REAR (L)
DISC
4 5 6
VCD
EFFECT (REAR R)
DISC
7 8 9
/P
VCD
SEA MODE DAP MODE SURR MODE
CONTROL
10 0 +10
RETURN FM MODE/MUTING
TV / VCR / TUNER
/ CD / DVD / VCD
SOUND
CONTROL
CONTROL
TAPE VCR
MENU MENU
EXIT SET
You can operate JVC's audio and video components with this receiver's remote control, since control signals
for JVC components are preset in the remote control.
Notes:
• If you use the buttons on the front panel or the menu function to choose a source, the remote control will
not operate that source. To operate a source with the remote control, the source must be selected using
buttons on the remote control.
• Check to see if its remote control mode selector is set to the correct position.
Normally, set it to the "TV / VCR / TUNER / CD / DVD / VCD" position.
To activate the 10 keys for adjusting the sound, set it to the "SOUND CONTROL" position.
• Refer also to the manuals supplied with your components.
IMPORTANT
To operate JVC's audio components using this remote control:
• You need to connect JVC audio components through the COMPU LINK-3 (SYNCHRO) jacks
(see page 41) in addition to the connections using cables with RCA pin plugs (see page 8).
• Aim the remote control directly at the remote sensor on the receiver.
Tuner
After pressing FM/AM (with the remote control mode selector set to the "TV / VCR / TUNER / CD / DVD /
VCD" position), you can perform the following operations:
FM/AM: Alternates between FM and AM.
1 — 10, +10: Selects a preset channel number directly.
For channel number 5, press 5. For channel number 15, press +10, then 5. For
channel number 20, press +10, then 10.
FM MODE/MUTING: Changes the FM reception mode.
Sound control section (Amplifier)
With the remote control mode selector set to the "SOUND CONTROL" position, you can perform the
following operations:
SEA MODE: Changes the SEA modes.
DAP MODE: Changes the DAP modes.
SURR MODE: Changes the surround modes.
CNTR +/–: Changes the center speaker output level for the DVD MULTI playback and surround
modes.
REAR•(L) +/–: Changes the left/right rear speaker output level for DAP and surround modes.
Changes the left rear speaker output level for the DVD MULTI playback mode.
(REAR•R) +/–: Changes the right rear speaker output level for the DVD MULTI playback mode.
EFFECT: Changes the effect level for DAP and surround modes.
DELAY: Changes the delay time for surround modes.
TEST: Checks the speaker output level for surround modes.
Note:
After adjusting sounds, set the remote control mode selector to the "TV / VCR / TUNER / CD / DVD / VCD"
position to operate your target source by using 10 keys; otherwise, 10 keys cannot be used for operating your
target source.
Page 44