Using The Remote Control; Using The Remote Control For Operating Jvc Audio/Video Components - JVC RX-730R Instructions Manual

Using the Remote Control

Using the Remote Control for Operating JVC Audio/Video Components

Tuner
FM AM
Remote: Outside
TUNER
– +
DELAY
CENTER
1 2 3 4
+
–
REAR
TEST
5 6 7/P 8
FM
MODE/MUTE
9 10 0 +10
PRESET TV
CHANNEL VOLUME
PTY SELECT PTY SELECT
+
–
PTY SEARCH
TV/VIDEO
TAPE
DISPLAY MODE
Remote: Inside
Sound control section (Amplifier)
SURROUND
MODE
SEA
MODE
Remote: Outside
SOUND
CONTROL
Remote: Inside
– +
DELAY
CENTER
1 2 3 4
+
–
REAR
TEST
5 6 7/P 8
FM
MODE/MUTE
9 10 0 +10
PRESET TV
CHANNEL VOLUME
PTY SELECT PTY SELECT
– +
PTY SEARCH
TV/VIDEO
TAPE
DISPLAY MODE
Remote: Inside
Using this remote control, you can operate audio/video components of not only JVC's but also the other
manufacturers'. To operate the other manufacturers' components, see page 47.
IMPORTANT:
To operate JVC audio components using this remote control:
• You need to connect JVC audio components through the COMPU LINK-3 (SYNCHRO) jacks (see page
41) in addition to the connections using cables with RCA pin plugs (see page 9).
• Aim the remote control directly at the remote sensor on the receiver.
• Select a source with the buttons on the SOURCE SELECT section (outside panel) of the remote control,
or press the buttons on the remote mode section (inside panel) of the remote control. If you select a source
on the front panel or using the menu function, the remote control will not operate that source.
After pressing FM or AM (on the SOURCE SELECT section of the outside panel) or TUNER (on the remote
mode section of the inside panel), you can perform the following operations on the built-in tuner:
1 – 10, +10
FM MODE/MUTE
PRESET CHANNEL +/–
RDS operating buttons
PTY SEARCH
PTY SELECT +/–
DISPLAY MODE
Note:
To activate the remote control for tuner operations, you can use the FM button or the AM button on the
SOURCE SELECT section or the TUNER button on the remote mode section. If you press the button on
the remote mode section, you can operate the tuner using the remote control, but the playing source will
not be changed to "FM" or "AM."
You can always perform the following operations:
SURROUND MODE
SEA MODE
After pressing SOUND CONTROL on the remote mode section of the inside panel, you can perform the
following operations:
CENTER +/–
REAR +/–
DELAY
TEST
Note:
After adjusting sounds, press the corresponding button on the remote mode section to operate your target
source by using 10 keys; otherwise, 10 keys cannot be used for operating your target source.
Selects the preset channels directly.
For preset channel number 5, press 5.
For preset channel number 15, press +10, then 5.
For preset channel number 20, press +10, then 10.
For preset channel number 30, press +10, +10, then 10.
Changes the FM reception mode.
Changes the preset channels.
Starts and ends searching a broadcast using the RDS.
Selects a program type.
Changes the RDS display mode.
Changes the surround modes.
Changes the SEA modes.
Changes the center speaker output level for the surround modes.
Changes the left/right rear speaker output level for surround modes.
Changes the delay time for surround modes.
Checks the speaker output level for surround modes.
Page 42