Table of Contents
Advertisement
Connecting the FM and AM Antennas
FM Antenna Connections
1
2
ANTENNA
FM
(75 )
FM
GND
GND
AM
LOOP
AM
EXT
How to strip the 75 coaxial cable and connect it to the FM terminals
1. Strip back the outside covering of the 75 coaxial cable to expose the braided metallic mesh about 20 mm.
2. Pull the mesh back and twist it into a single connector, as shown in the illustration above.
3. Strip the insulation about 10 mm back from the central wire.
4. Insert the twisted mesh and the central wire to the FM terminals, as shown in the illustration above.
AM Antenna Connections
ANTENNA
FM
(75 )
FM
GND
GND
AM
LOOP
AM
EXT
Note:
Make sure the antenna conductors do not touch any
other terminals, connecting cords and power cord.
This could cause poor reception.
Page 5
3
FM Antenna
4
Outside FM Antenna Wire
2
1
20 mm
AM Loop Antenna
1
2
Extend the FM wire antenna horizontally.
If reception is poor, connect the outside antenna.
Before attaching a 75
with a round wire going to an outside antenna),
disconnect the supplied FM antenna.
3
10 mm
Turn the loop until you have
the best reception.
Snap the tabs on the loop into the slots of
the base to assemble the AM loop.
3
Outdoor Single Vinyl-covered Wire
If reception is poor, connect an outdoor single vinyl-covered
wire to the AM EXT terminal. (Keep the AM loop antenna
connected.)
coaxial cable (the kind
Advertisement
Table of Contents
