JVC RX-80PGD Instructions Manual page 35

Preparing for the surround mode
DAP/SURROUND MODE
Front panel
DAP/SURROUND/DVD MULTI
ADJUST
Once you have set the surround modes, you can use the same adjustment every time you want to activate the
surround you want. The receiver memorizes surround adjustments for each mode.
Note:
When you select "DVDMULTI" as the source to play, you cannot select or adjust the surround mode.
On the front panel:
1. Press DAP/SURROUND MODE so that the Control % / fi / @ / # buttons work for selecting
the DAP/surround modes.
The lamp next to the button lights up.
2. Press Control @ / # to select the surround mode.
The SURROUND indicator lights up on the display.
Each time you press the button, the DAP and surround modes alternately come into effect.
3. Press Control % / fi until the surround mode you want appears on the display.
Each time you press the button, the surround modes change as follows (the indicator of the selected
surround mode also lights up on the display):
PROLOGIC
SURR OFF
(Surround Off)
PROLOGIC: Select this mode to watch a video source with Dolby Surround when you have
connected the rear speakers (and a center speaker).
3CHLOGIC: Select this mode to watch a video source with Dolby Surround when you have
connected a center speaker and no rear speakers.
THEATER1: Select this mode to watch a video source with Dolby Surround when you have
connected the rear speakers (and a center speaker).
This mode gives you the feeling of a small movie theater with a seating capacity
of 100.
THEATER2: Select this mode to watch a video source with Dolby Surround when you have
connected the rear speakers (and a center speaker).
This mode gives you the feeling of a large movie theater with a seating capacity
of 1000.
SURR OFF: No surround mode is applied.
4. Press DAP/SURROUND/DVD MULTI ADJUST so that the Control % / fi / @ / # buttons work
for adjusting the surround mode.
The lamp next to the button lights up.
3CHLOGIC
THEATER2 THEATER1
To be continued to the next page
Page 32