Using The Remote Control For Operating Jvc Audio/Video Components - JVC RM-SR630RU Instructions Manual

Using the Remote Control for Operating JVC Audio/Video Components

/I
SLEEP TV VCR AUDIO
SEA MODE ONE TOUCH CD-DISC
OPERATION
1 2 3
4 5 6
8 9
7/P
+10 0 10
TV
CENTER REAR CH
VOLUME
SURROUND CONTROL
ON/OFF MODE DELAY
VCR
FM/AM
PTY+
DISPLAY PTY
MODE SEARCH
PTY–
RM -SR630RU
REM OTE CONTROL
You can operate JVC's audio and video components with this receiver's remote control.
To operate these components with the remote control, first select a source with the source selecting buttons
on the remote control. Then, operate that source using the remote control.
Note:
If you choose a source on the front panel, the remote control will not operate that source. To operate a source
with the remote control, the source must be selected using buttons on the remote control.
IMPORTANT:
To operate JVC's audio components using this remote control:
• You need to connect JVC audio components through the COMPU LINK-3 (SYNCHRO) jacks
(see page 35) in addition to the connections using cables with RCA pin plugs (see page 9).
• Aim the remote control directly at the remote sensor on the receiver.
After pressing FM/AM, you can perform the following operations:
FM/AM Alternates between FM and AM (MW/LW).
1 — 10, +10 Selects a preset channel number directly.
To select channel number 5, press 5. For channel number 15, press +10, then 5. For
channel number 20, press +10, then 10.
After pressing CD, you can perform the following operations on a CD player:
Starts playing.
3
Returns to the beginning of the current (or previous) track.
4
Skips to the beginning of the next track.
¢
Stops playing.
7
Pauses. To release pause, press 3.
8
1 — 10, +10 Selects a track number directly.
To select track number 5, press 5. For track number 15, press +10, then 5. For track
number 20, press +10, then 10.
After pressing CD-DISC, you can perform the following operations on a CD player-changer:
1 — 6, 7/P Select the number of a disc installed in a CD player-changer. Then continue to
operate the CD player as described above.
After pressing TAPE, you can perform the following operations on a cassette deck:
Starts playback.
3
Fast winds a tape from right to left.
1
Fast winds a tape from left to right.
¡
Stops operation.
7
Pauses. To release pause, press 3.
8
Page 36